HI-FI Collective cable kit 6
Some time ago I built interconnect cable kit #6 from HI-FI Collective. It's been in my system now for some time and has been used in quite a few situations. Firstly, it's been used to connect an Arcam rDAC to my Roksan K2, secondly, it's been used to connect my Cambridge Audio 752BD to my Arcam AVR380 and lastly at the...
Orbit, a high performance DIY turntable.
What I really like about Rega decks is that they are very easy to upgrade. In fact there is no need to perform all upgrades in one go, one can start with the TT PSU, then the platter and sub-platter and so on. This means a high performing deck can be purchased slowly in steps. In fact my first attempt at...
Turntable building - the history
Starting out with a P3-24 deck. My deck started life as a refurbished P3-24 unit, with no mods made to it. Firstly, after much reading I purchased the TT motor control unit; which is available from many retailers at reasonable cost. It should be said that this is one of the easiest and most effective upgrades that you can me,...
Things learnt from building the first turntable.
The area under the platter was too thin, and tended to concentrate vibration around the platter main bearing sleeve. This was fixed by brute force to avoid vibration in the first place (a very large granite / MDF block below the plinth). The positioning of the motor and circuit led to some noise, and only earthing to motor prevented it. It...
These may be of interest
- Similar - Write XML with GroovyBuilder
- Similar - Wrapping JFreeChart as a Groovy builder
- Similar - Reading XML in groovy using XmlParser
- Similar - Generate an ATOM feed with GroovyBuilder
- Similar - Groovychart Bar chart with fixed colour
Supporting us
We maintain several popular embedded projects and work hard to make them even better. If you're looking for commercial services, please do consider us.
Alternatively, you can buy us a coffee to say thanks.
Sharing links
Learn about TcMenu
Learn about our rapid development framework TcMenu.
